I wanted a quick, easy to build robot kit to get back into electronics and robotics. I ask for a Herbie the Mouse Bot for Christmas and sure enough I got one. It was a fun kit to build and went together in a little over an hour.

You start off with a PC board…

… and a handful of components…

You break apart the PC board which serves as a PC board and a body for the mouse which, is pretty cool.

The PC boards join together via several solder joints. Tape is used to keep everything together until you are done soldering. A smaller board that holds the 9 volt battery connector helps keep the three main sides together. By the time you are done soldering all the joints it is a pretty sturdy little robot.

The whiskers and tail activate a relay when bumped so the mouse will backup to avoid getting stuck. I taped the relay down while I soldered it in.

Herbie with the photo diode “eyes” installed….

Herbie just about finished…

Herbie is an interesting robot because it uses a simple analog IC, the LM386, to do something you might think requires a much more complicated digital circuit or micro-controller/processor:

http://downloads.solarbotics.net/PDF/Solarbotics_Herbie_the_Mousebot_Instruction.pdf

We don’t have much open bare floor in the house and it moves quite fast so it was a bit of a challenge to keep it under control without hitting too much:

The Herbie Kit is well engineered and fun to assemble. I give it five stars and recommend it as a good first robot kit.